Missing "link" from dev to slot #5
Description
I have a disk server with an LSI MegaRaid SAS controller in JBOD mode:
[ 12.716078] megaraid_sas 0000:02:00.0: FW restarted successfully from megasas_init_fw!
[ 44.204956] megaraid_sas 0000:02:00.0: FW now in Ready state
[ 44.205266] megaraid_sas 0000:02:00.0: firmware supports msix : (96)
[ 44.205269] megaraid_sas 0000:02:00.0: current msix/online cpus : (12/12)
[ 44.205272] megaraid_sas 0000:02:00.0: RDPQ mode : (enabled)
[ 44.205503] megaraid_sas 0000:02:00.0: Current firmware maximum commands: 4064 LDIO threshold: 0
[ 44.356968] megaraid_sas 0000:02:00.0: Init cmd success
[ 44.384952] megaraid_sas 0000:02:00.0: firmware type : Extended VD(240 VD)firmware
[ 44.384957] megaraid_sas 0000:02:00.0: controller type : MR(2048MB)
[ 44.384959] megaraid_sas 0000:02:00.0: Online Controller Reset(OCR) : Enabled
[ 44.384961] megaraid_sas 0000:02:00.0: Secure JBOD support : Yes
[ 44.413121] megaraid_sas 0000:02:00.0: INIT adapter done
[ 44.414667] megaraid_sas 0000:02:00.0: pci id : (0x1000)/(0x005d)/(0x15d9)/(0x0a09)
[ 44.414669] megaraid_sas 0000:02:00.0: unevenspan support : no
[ 44.414672] megaraid_sas 0000:02:00.0: firmware crash dump : no
[ 44.414674] megaraid_sas 0000:02:00.0: jbod sync map : yes
[ 44.414678] scsi host0: Avago SAS based MegaRAID driver
The controller is attached to two enclosures:
[ 44.415337] scsi 0:0:0:0: Enclosure LSI SAS3x28 0601 PQ: 0 ANSI: 5
[ 45.065359] scsi 0:0:1:0: Enclosure LSI SAS3x40 0601 PQ: 0 ANSI: 5
There are disks on both enclosures, but something seems missing (reduced number of lines):
# encled
ENCLOSURE/SLOT DEV FAULT_LED LOCATION_LED
----------------------------------------------------
0:0:1:0/Slot16 ---- fault_off locate_off
0:0:1:0/Slot06 ---- fault_off locate_off
0:0:1:0/Slot14 ---- fault_off locate_off
0:0:1:0/Slot04 ---- fault_off locate_off
0:0:1:0/Slot22 ---- fault_off locate_off
and
# sdled
sdled is deprecated. Use encled
DEVICE NAME STATUS
/dev/sdy N/A
/dev/sdf N/A
/dev/sdab N/A
/dev/sdo N/A
Is there some way to go from /dev/sd* to enc:slot ? Something I should enable?
Tks.