Ctrl+Enter command missing from help panel and tutorial

[piersy]

As in the title without Ctrl+enter you need to resort to using the mouse which kinda breaks the flow.

[flamingcow66]

I'll add better documentation for this. Out of curiosity, could you please walk me through how lack of it forces you to use the mouse?

[piersy]

Hey, following the tutorial, Anoter Link heading steps 5 & 6

Navigate to the blank second node in the link
Label it backend1

At this point without ctrl+enter or the mouse I cannot see any way to edit the second node in the link.

See current diagram state

[flamingcow66]

Your point is quite right about documenting ctrl-enter better. However, I'm still a bit confused on where you got hung up on the tutorial, and I'd like to improve that for future readers.

Does [down arrow], [enter] not get you to editing the second node from the point in your screenshot?

[piersy]

I hadn't realised that enter would allow me to edit a node's contents.

[down arrow], [enter] does get me to editing the node and so does [down arrow], [right arrow].

I was using [J], [L] which from the documentation look like they should map to the same functionality as [down arrow], [enter] or [down arrow], [right arrow], but pressing [L] while on a node inside a link cycles through the nodes in the link, when I would in fact expect it to allow me to edit the link.